Maxim MAXQ3183电能测量前端方案
maxim 公司的maxq3183是专用的电能测量前端ic,收集和计算多相电压,电流,功率,能量,以及多相负载的其它测量和电源质量参数.计算结果通过spi总线由外接主机进行处理. maxq3183和三相/3线以及三线/4线兼容,单电源3.3v 工作,典型低功耗为35mw.主要用于三相多功能电表.本文介绍maxq3183主要特性,方框图, 简化时钟源, 能量计算的相位补偿框图, 表观和无功电能计算框图,以及典型应用电路图.
the maxq3183 is a dedicated electricity measurement front-end that collects and calculates polyphase voltage, current, power, energy, and many other metering and power-quality parameters of a polyphase load. the computed results can be retrieved by an external master through the on-chip serial peripheral interface (spi™) bus. this bus is also used by the external master to configure the operation of the maxq3183 and monitor the status of operations.
the maxq3183 performs voltage and current measurements using an integrated adc that can measure up to seven external differential signal pairs. an eighth differential signal pair is used to measure the die temperature.
an internal amplifier automatically adjusts the current channel gain to compensate for low-current channel-signal levels.
maxq3183主要特性:
♦ compatible with 3-phase/3-wire, 3-phase/4-wire
♦ active power and energy of each phase and combined 3-phase (kwh), positive and negative
♦ reactive power and energy of each phase and combined, positive and negative
♦ apparent power and energy of each phase and combined 3-phase
♦ neutral line current measurement
♦ vector sum of 3-phase currents and neutral current
♦ line frequency (hz)
♦ power factors
♦ voltage phasor angles
♦ voltage and current phase sequence indications
♦ phase voltage absence detection
♦ voltage and current harmonic measurement
♦ phase current thdn
♦ fundamental and total power and energy
♦ ac/dc mode current and voltage measurement
♦ two pulse outputs: configurable for active, reactive, and apparent powers
♦ programmable meter constants and pulse widths
♦ programmable no-load current threshold
♦ programmable thresholds for undervoltage and overvoltage detection
♦ programmable threshold for overcurrent detection
♦ programmable vector sum threshold for bypass detection
♦ amp-hours in absence of voltage signals
♦ on-chip digital temperature sensor
♦ precision internal voltage reference 2.048v (30ppm/°c typical), also supports an external voltage reference
♦ supports software meter calibration
♦ up to 3-point multipoint calibration to compensate for transducer nonlinearity
♦ power-fail detection
♦ bidirectional reset input/output
♦ spi-compatible serial interface with interrupt request (irq) output
♦ single 3.3v supply, low power (35mw typical)
maxq3183应用:
3-phase multifunction electricity meters
图1.maxq3183方框图
图2.maxq3183简化时钟源
图3.maxq3183能量计算的相位补偿框图
图4.maxq3183表观和无功电能计算框图
图5.maxq3183典型应用电路图
安超云荣获可信云2022-2023年度技术最佳实践奖！
入门级全画幅相机选什么好？三款入门级全画幅相机推荐
新手做跨境电商独立站？轻量云服务器让你不迷茫
一加8系列或定档2020年第二季度 后置三摄回归竖形排列
关于NB-IOT无线技术的介绍
Maxim MAXQ3183电能测量前端方案
一文看懂RFID RC522和PN532的区别
现代化高科技的最新产物，智能镜子显示屏问世
激光切割机有着广泛的应用，它的优势有哪些
什么是数字式传感器
美国研发出一种防撞防火锂电池 未来还将打造防弹电池
青铜剑技术基于二代ASIC芯片即插即用的驱动器6CP0215T12-A11
BanQu利用区块链技术为没有银行账户的人提供身份证明
“Bug”微型无人机原型机可在恶劣天气中使用
电脑给手机充电速度慢？USB快充线自己做,USB WIRE
苹果Siri或提供自定义语音方法
二氧化碳气体保护焊怎么调电流电压
Vishay企业的产品与发展介绍
海信胶片DP2988H水平亮线
智能语音助手在旅游行业的应用与挑战
the maxq3183 is a dedicated electricity measurement front-end that collects and calculates polyphase voltage, current, power, energy, and many other metering and power-quality parameters of a polyphase load. the computed results can be retrieved by an external master through the on-chip serial peripheral interface (spi™) bus. this bus is also used by the external master to configure the operation of the maxq3183 and monitor the status of operations.
the maxq3183 performs voltage and current measurements using an integrated adc that can measure up to seven external differential signal pairs. an eighth differential signal pair is used to measure the die temperature.
an internal amplifier automatically adjusts the current channel gain to compensate for low-current channel-signal levels.
maxq3183主要特性:
♦ compatible with 3-phase/3-wire, 3-phase/4-wire
♦ active power and energy of each phase and combined 3-phase (kwh), positive and negative
♦ reactive power and energy of each phase and combined, positive and negative
♦ apparent power and energy of each phase and combined 3-phase
♦ neutral line current measurement
♦ vector sum of 3-phase currents and neutral current
♦ line frequency (hz)
♦ power factors
♦ voltage phasor angles
♦ voltage and current phase sequence indications
♦ phase voltage absence detection
♦ voltage and current harmonic measurement
♦ phase current thdn
♦ fundamental and total power and energy
♦ ac/dc mode current and voltage measurement
♦ two pulse outputs: configurable for active, reactive, and apparent powers
♦ programmable meter constants and pulse widths
♦ programmable no-load current threshold
♦ programmable thresholds for undervoltage and overvoltage detection
♦ programmable threshold for overcurrent detection
♦ programmable vector sum threshold for bypass detection
♦ amp-hours in absence of voltage signals
♦ on-chip digital temperature sensor
♦ precision internal voltage reference 2.048v (30ppm/°c typical), also supports an external voltage reference
♦ supports software meter calibration
♦ up to 3-point multipoint calibration to compensate for transducer nonlinearity
♦ power-fail detection
♦ bidirectional reset input/output
♦ spi-compatible serial interface with interrupt request (irq) output
♦ single 3.3v supply, low power (35mw typical)
maxq3183应用:
3-phase multifunction electricity meters
图1.maxq3183方框图
图2.maxq3183简化时钟源
图3.maxq3183能量计算的相位补偿框图
图4.maxq3183表观和无功电能计算框图
图5.maxq3183典型应用电路图
安超云荣获可信云2022-2023年度技术最佳实践奖！
入门级全画幅相机选什么好？三款入门级全画幅相机推荐
新手做跨境电商独立站？轻量云服务器让你不迷茫
一加8系列或定档2020年第二季度 后置三摄回归竖形排列
关于NB-IOT无线技术的介绍
Maxim MAXQ3183电能测量前端方案
一文看懂RFID RC522和PN532的区别
现代化高科技的最新产物，智能镜子显示屏问世
激光切割机有着广泛的应用，它的优势有哪些
什么是数字式传感器
美国研发出一种防撞防火锂电池 未来还将打造防弹电池
青铜剑技术基于二代ASIC芯片即插即用的驱动器6CP0215T12-A11
BanQu利用区块链技术为没有银行账户的人提供身份证明
“Bug”微型无人机原型机可在恶劣天气中使用
电脑给手机充电速度慢？USB快充线自己做,USB WIRE
苹果Siri或提供自定义语音方法
二氧化碳气体保护焊怎么调电流电压
Vishay企业的产品与发展介绍
海信胶片DP2988H水平亮线
智能语音助手在旅游行业的应用与挑战